R3303-HP HSR6800 Routers MPLS Command Reference

227
Parameters
ethernet: Specifies the VC type as Ethernet.
vlan: Specifies the VC type as VLAN mode.
Examples
# Configure the VC type as Ethernet.
<Sysname> system-view
[Sysname] pw-class pw100
[Sysname-pw-pw100] trans-mode ethernet
vpn-target (MPLS L2VPN view)
Use vpn-target to configure route targets for an MPLS L2VPN.
Use undo vpn-target to remove the specified or all route targets of an MPLS L2VPN.
Syntax
vpn-target vpn-target&<1-16> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | { vpn-target&<1-16> [ both | export-extcommunity | import-extcommunity ] }
Views
MPLS L2VPN view
Default command level
2: System level
Parameters
vpn-target&<1-16>: Adds route target extended community attributes to the import route target extended
community attribute list (Import Target) or export route target extended community attribute list (Export
Target). &<1-16> means that you can add up to 16 route targets.
A route target attribute can be a string of 3 to 21 characters in one of these formats:
• 16-bit AS number:32-bit user-defined number. For example, 101:3.
• 32-bit IP address:16-bit user-defined number. For example, 192.168.122.15:1.
• 32-bit AS number:16-bit user-defined number, where the AS number must be equal to or greater
than 65536. For example, 65536:1.
both: Uses the specified route targets as both import targets and export targets. The both keyword is also
used when you do not specify any of both, export-extcommunity, and import-extcommunity.
export-extcommunity: Uses the specified route targets as export targets.
import-extcommunity: Uses the specified route targets as import targets.
all: Removes all route targets.
Usage guidelines
By default, an MPLS L2VPN has no route targets. You must configure route targets when creating an MPLS
L2VPN.
Examples
# Configure export route targets as 1:1 and 1:2, and import route target as 1.2.3.4:11 for the MPLS
L2VPN vpn1.