R3303-HP HSR6800 Routers MPLS Command Reference

266
Default
No tunneling policy is specified for a VPLS instance and the default tunneling policy is used. The default
tunneling policy selects only one tunnel (no load balancing) in this order: LSP tunnel, GRE tunnel, CR-LSP
tunnel.
Views
VSI view
Default command level
2: System level
Parameters
tunnel-policy-name: Name of the tunneling policy for the VPLS instance, a string of 1 to 19 characters
without any blank space.
Usage guidelines
If you specify a tunneling policy name but the tunneling policy is not configured, the default tunneling
policy is used. For information about configuring a tunneling policy, see MPLS Configuration Guide.
Examples
# Specify that VPLS instance aaa uses the tunneling policy of policy1.
<Sysname> system-view
[Sysname] vsi aaa
[Sysname-vsi-aaa] tnl-policy policy1
Related commands
tunnel-policy
trans-mode
Use trans-mode to specify the PW transport mode.
Use undo trans-mode to restore the default.
Syntax
trans-mode { ethernet | vlan }
undo trans-mode
Default
The PW transport mode is VLAN.
Views
PW class view
Default command level
2: System Level
Parameters
ethernet: Specifies the PW transport mode as Ethernet mode.
vlan: Specifies the PW transport mode as VLAN mode.