HP 6800 Router Series - HP HSR6800-CMW520-R3103P02 Release Notes

6
PCB Version: Ver.C
Logic Version: 2.0
Basic BootWare Version: 1.06
Extend BootWare Version: 1.06
[FIXED PORT] GE3/0/0 (Hardware)Ver.A, (Driver)1.0, (Cpld)1.0
[FIXED PORT] GE3/0/1 (Hardware)Ver.A, (Driver)1.0, (Cpld)1.0
[SUBSLOT 1] The SubCard is not present
[SUBSLOT 2] HIM-CL2P(E) (Hardware)Ver.B, (Driver)1.0, (Cpld)1.0
Upgrading restrictions and guidelines
None.
Restrictions and cautions
The network management interface of HSR6808 was set to 5/0/0 in pre-production units; it is now
standardized to 0/0/0.
Open problems and workarounds
None.
List of resolved problems
Resolved Problems in CMW520-R3103P02
RTD066142
 Symptom: After the OSPF default route is deleted, the standby MPU prints the message "The default
route has been changed or deleted, protocol is OSPF", which should be output by the active MPU.
 Condition: This symptom occurs when the following conditions exist:
The router has two MPUs.
OSPF NSR is enabled.
An OSPF default route exists.
RTD066144
 Symptom: When the DHCP relay agent on the device receives a DHCP packet in which the length
value in Option 82 is larger than the actual field length, the SR6600 reboots.
 Condition: This symptom occurs when the DHCP relay agent on the device receives a DHCP packet
in which the length value in Option 82 is larger than the actual field length.
RTD066403
 Symptom: When session control is enabled on the AAA server and a RADIUS key is configured on
device, users might fail to get online.