HP Comware 5 Debug Manual Vol 2

Reply from 22.2.2.43: bytes=56 Sequence=1 ttl=255 time=27 ms
--- 22.2.2.43 ping statistics ---
1 packet(s) transmitted
1 packet(s) received
0.00% packet loss
round-trip min/avg/max = 27/27/27 ms
// The state value of the data link layer protocol is 3 (data transmission state). A
single-protocol-encapsulated information frame was received on interface Serial 2/0.
X.25 debugging commands
debugging pad
Use debugging pad to enable a type of PAD debugging.
Use undo debugging pad to disable a type of PAD debugging.
Syntax
debugging pad { all | error | event | packet }
undo debugging pad { all | error | event | packet }
Default
All types of PAD debugging are disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: All types of PAD (the packet assembly/disassembly facility) debugging.
error: Debugging for PAD errors.
event: Debugging for PAD events.
packet: Debugging for PAD packets.
Usage guidelines
Table 5 describes the output fields and messages for the debugging pad error command.
Table 212 Output from the debugging pad error command
Field
Description
PAD: Failed to create PadCB X.25 failed to create PAD control block.
PAD: X.25 LCD down X.25 virtual link went down.
Table 6 describes the output fields and messages for the debugging pad event command.
310