HP HSR6802 HSR6804 HSR6808 Routers Installation Guide

98
Item Remarks
Memory type and size
• Default—Two 1-GB DDR2 SDRAMs
• Maximum—Two 2-GB DDR2 SDRAMs
NVRAM 128 KB
Combo interface
2
2 copper ports (MDI/MDIX
autosensing)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 fiber ports 1000 Mbps, full-duplex
HIM 2 supported
MIM 2 supported
Hardware encryption Supported
Hot swapping Supported
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the copper por
t
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
see
HP HSR6800 Routers Interface Command Reference .
• Use transceiver modules for the fiber ports provided by HP only. The router mi
g
ht be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-210 combo interface specifications
Specification of combo interfaces on the FIP-210 and the FIP-110 are the same. For more information,
see Table 34 and Table 35.
T
ransceiver modules for the FIP-210 and for the FIP-110 fiber ports are the same. For more information,
see Table 36.
Maximum interface modules provided by FIP-210 in full configuration
FIP/Interface
module
HSR6802 HSR6804 HSR6808
FIP-210 2 4 8
MIM 4 8 16
HIM 4 8 16
FIP-300
The FIP-300 supports HIMs and MIMs, and it provides 12 combo interfaces.