HP HSR6802 HSR6804 HSR6808 Routers Installation Guide

99
FIP-300 front panel
Figure 93 FIP-300 front panel
(1) HIM/MIM slot (2) GE0 throu
g
h GE11 copper ports
(3) GE0 throu
g
h GE11 fiber ports
FIP-300 specifications
Item Remarks
Flash 8 MB
Memory type and size
• Default—Two 2-GB DDR3 SDRAMs
• Maximum—Two 2-GB DDR3 SDRAMs
NVRAM 128 KB
Combo interface
12
Copper ports (MDI/MDIX
autosensing)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
Fiber ports 1000 Mbps, full-duplex
HIM 1 supported
MIM 1 supported
Hardware encryption Supported
Hot swapping Supported
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the copper por
t
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
see
HP HSR6800 Routers Interface Command Reference .
• Use transceiver modules for the fiber ports provided by HP only. The router mi
g
ht be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-300 combo interface specifications
Specification of combo interfaces on the FIP-300 is the same as FIP-110. For more information, see Table
34 and Table 35.
T
ransceiver modules for the FIP-300 are the same as the FIP-110. For more information, see Table 36.