HP HSR6802 HSR6804 HSR6808 Routers Installation Guide

103

NOTE:

• For a combo interface, the default operating port is the copper port. You can use either the copper por

or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }

command in interface view. For more information about the combo enable { copper | fiber } command,

see

HP HSR6800 Routers

Interface Command Reference

• Use transceiver modules for the fiber ports provided by HP only. The router mi

ht be incompatible with

transceiver modules from other manufacturers. The system generates an alarm when a transceiver

module from another manufacturer is installed.

FIP-600 combo interface specifications

Specification of combo interfaces on the FIP-600 and the FIP-110 are the same. For more information,

see Table 34 and Table 35.

ransceiver modules for the FIP-600 and for the FIP-110 fiber ports are the same. For more information,

see Table 36.

Maximum interface modules provided by FIP-600 in full configuration

FIP/Interface

module

HSR6802 HSR6804 HSR6808

FIP-600 2 4 8

MIM Not supported Not supported Not supported

HIM 4 8 16

SAP-48GBE

SAP-48GBE front panel

Figure 96 SAP-48GBE front panel

(1) LEDs for GE ports 0 to 47 (2) SAP module status LED (RUN)

(3) GE ports 0 to 47 (4) Ejector lever

(5) Captive screw

SAP-48GBE specifications

Table 38 SAP-48GBE specifications

Item Remarks

Flash 4 MB