HP HSR6802 HSR6804 HSR6808 Routers Installation Guide

1 38 -10 53

4 34 -10 53

Table 18 Command output

Field Descri

tion

SlotNo Slot number of the card.

Temperature Current temperature of the card.

Lower limit Low temperature threshold of the card.

Upper limit High temperature threshold of the card.

Port configuration and management

Configuring a combo interface

A combo interface is a logical interface that comprises an SFP port of a transceiver module and an RJ-45

Ethernet port. The two ports share one forwarding interface, so they cannot work simultaneously. When

you enable either port, the other port is automatically disabled. You can select to activate a port as

needed.

Use the display interface interface-type interface-number command to find out which port is an SFP port

and which port is an RJ-45 Ethernet port.

• If the output includes "Media type is optical fiber," it means that the port is an SFP port. For example,

the following output shows that GigabitEthernet 5/0/1 is an SFP port.

[Sysname] display interface GigabitEthernet 5/0/1

GigabitEthernet4/0/0 current state: DOWN

Line protocol current state: DOWN

Description: GigabitEthernet4/0/0 Interface

The Maximum Transmit Unit is 1500

Internet protocol processing : disabled

IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 2222-2222-2122

IPv6 Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 2222-2222-2122

Media type is optical fiber, loopback not set, promiscuous mode not set

…

• If the output includes "Media type is twisted pair," it means that the interface is an RJ-45 Ethernet

port. For example, the following output shows that GigabitEthernet 5/0/0 is an RJ-45 Ethernet port.

[Sysname] display interface GigabitEthernet 5/0/0