R3303-HP HSR6800 Routers High Availability Command Reference

27
CFD configuration commands
The commands in this chapter are supported only when the SAP module is operating in bridge mode.
cfd cc enable
Use cfd cc enable to enable CCM sending on a specified MEP.
Use undo cfd cc enable to disable CCM sending on a specified MEP.
Syntax
cfd cc service-instance instance-id mep mep-id enable
undo cfd cc service-instance instance-id mep mep-id enable
Default
The CCM sending function is disabled.
Views
Layer 2 Ethernet interface view
Default command level
2: System level
Parameters
service-instance instance-id: Specifies the service instance ID in the range of 1 to 32767.
mep mep-id: Specifies the ID of a MEP, in the range of 1 to 8191.
Examples
# On port GigabitEthernet 3/0/1, enable CCM sending on MEP 3 in service instance 5.
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] cfd cc service-instance 5 mep 3 enable
Related commands
cfd cc interval
cfd cc interval
Use cfd cc interval to set the value of the interval field in the CCM messages.
Use undo cfd cc interval to restore default.
Syntax
cfd cc interval interval-value service-instance instance-id
undo cfd cc interval service-instance instance-id
Default
The value of this field is 4 for all CCMs sent.