R3303-HP HSR6800 Routers High Availability Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP HSR68xx Configure-to-Order Router Solution

111

112

113

114

115

116

117

118

119

120

104

[RouterG-rrpp-domain1] quit

# Enable RRPP.

[RouterG] rrpp enable

8. Configure Router H:

# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region

configuration.

<RouterH> system-view

[RouterH] vlan 1 to 30

[RouterH] stp region-configuration

[RouterH-mst-region] instance 1 vlan 1 to 30

[RouterH-mst-region] active region-configuration

[RouterH-mst-region] quit

# Set the physical state change suppression interval to 0 seconds on GigabitEthernet 3/0/1 and

GigabitEthernet 3/0/2. Disable the spanning tree feature, configure the two ports as trunk ports,

and assign them to VLANs 1 through 30.

[RouterH] interface gigabitethernet 3/0/1

[RouterH-GigabitEthernet3/0/1] link-delay 0

[RouterH-GigabitEthernet3/0/1] undo stp enable

[RouterH-GigabitEthernet3/0/1] port link-type trunk

[RouterH-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30

[RouterH-GigabitEthernet3/0/1] quit

[RouterH] interface gigabitethernet 3/0/2

[RouterH-GigabitEthernet3/0/2] link-delay 0

[RouterH-GigabitEthernet3/0/2] undo stp enable

[RouterH-GigabitEthernet3/0/2] port link-type trunk

[RouterH-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30

[RouterH-GigabitEthernet3/0/2] quit

# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1,

and configure the VLANs mapped to MSTI 1 as the protected VLANs of RRPP domain 1.

[RouterH] rrpp domain 1

[RouterH-rrpp-domain1] control-vlan 4092

[RouterH-rrpp-domain1] protected-vlan reference-instance 1

# Configure Router H as the master node of subring 5, with GigabitEthernet 3/0/1 as the primary

port and GigabitEthernet 3/0/2 as the secondary port, and enable subring 5.

[RouterH-rrpp-domain1] ring 5 node-mode master primary-port gigabitethernet 3/0/1

secondary-port gigabitethernet 3/0/2 level 1

[RouterH-rrpp-domain1] ring 5 enable

[RouterH-rrpp-domain1] quit

# Enable RRPP.

[RouterH] rrpp enable

9. Verify the configuration:

Use the display command to view RRPP configuration and operational information on each device.