R3303-HP HSR6800 Routers High Availability Configuration Guide

108
[RouterB-GigabitEthernet3/0/4] port trunk permit vlan 11
[RouterB-GigabitEthernet3/0/4] port trunk pvid vlan 11
[RouterB-GigabitEthernet3/0/4] quit
# Create RRPP domain 1, configure VLAN 100 as the primary control VLAN of RRPP domain 1,
and configure the VLAN mapped to MSTI 1 as the protected VLAN of RRPP domain 1.
[RouterB] rrpp domain 1
[RouterB-rrpp-domain1] control-vlan 100
[RouterB-rrpp-domain1] protected-vlan reference-instance 1
# Configure Router B as a transit node of primary ring 1 in RRPP domain 1, with GigabitEthernet
3/0/1 as the primary port and GigabitEthernet 3/0/2 as the secondary port, and enable ring 1.
[RouterB-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet 3/0/1
secondary-port gigabitethernet 3/0/2 level 0
[RouterB-rrpp-domain1] ring 1 enable
# Configure Router B as the assistant-edge node of subring 3 in RRPP domain 1, with
GigabitEthernet 3/0/4 as the edge port, and enable subring 3.
[RouterB-rrpp-domain1] ring 3 node-mode assistant-edge edge-port gigabitethernet
3/0/4
[RouterB-rrpp-domain1] ring 3 enable
[RouterB-rrpp-domain1] quit
# Create RRPP domain 2, configure VLAN 105 as the primary control VLAN of RRPP domain 2,
and configure the VLAN mapped to MSTI 2 as the protected VLAN of RRPP domain 2.
[RouterB] rrpp domain 2
[RouterB-rrpp-domain2] control-vlan 105
[RouterB-rrpp-domain2] protected-vlan reference-instance 2
# Configure Router B as the transit node of primary ring 1, with GigabitEthernet 3/0/1 as the
primary port and GigabitEthernet 3/0/2 as the secondary port, and enable ring 1.
[RouterB-rrpp-domain2] ring 1 node-mode transit primary-port gigabitethernet 3/0/1
secondary-port gigabitethernet 3/0/2 level 0
[RouterB-rrpp-domain2] ring 1 enable
# Configure Router B as the assistant-edge node of subring 2 in RRPP domain 2, with
GigabitEthernet 3/0/3 as the edge port, and enable subring 2.
[RouterB-rrpp-domain2] ring 2 node-mode assistant-edge edge-port gigabitethernet
3/0/3
[RouterB-rrpp-domain2] ring 2 enable
[RouterC-rrpp-domain2] quit
# Enable RRPP.
[RouterB] rrpp enable
3. Configure Router C:
# Create VLANs 11 and 12, map VLAN 11 to MSTI 1 and VLAN 12 to MSTI 2, and activate MST
region configuration.
<RouterC> system-view
[RouterC] vlan 11 to 12
[RouterC] stp region-configuration
[RouterC-mst-region] instance 1 vlan 11
[RouterC-mst-region] instance 2 vlan 12
[RouterC-mst-region] active region-configuration
[RouterC-mst-region] quit