R3303-HP HSR6800 Routers High Availability Configuration Guide

120
Configuring member ports for a smart link group
You can configure member ports for a smart link group either in smart link group view or in interface view.
The configurations made in these two views have the same effect.
In smart link group view
To configure member ports for a smart link group in smart link group view:
Ste
p
Command
1. Enter system view.
system-view
2. Create a smart link group and enter smart link
group view.
smart-link group group-id
3. Configure member ports for a smart link group.
port interface-type interface-number { master | slave }
In interface view
To configure member ports for a smart link group in interface view:
Ste
p
Command
1. Enter system view.
system-view
2. Enter Ethernet interface view or layer 2
aggregate interface view.
interface interface-type interface-number
3. Configure member ports for a smart link group.
port smart-link group group-id { master | slave }
Configuring role preemption for a smart link group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a smart link group and
enter smart link group view.
smart-link group group-id N/A
3. Enable role preemption.
preemption mode role N/A
4. Configure the preemption
delay.
preemption delay delay-time
Optional.
1 second by default.
The preemption delay
configuration takes effect only after
role preemption is enabled.
Enabling the sending of flush messages
Follow these guidelines when you enable the sending of flush messages:
• The control VLAN configured for a smart link group must be different from that configured for any
other smart link group.