R3303-HP HSR6800 Routers High Availability Configuration Guide

219
# Configure the interval between two consecutive tests as 100 milliseconds.
[RouterA-nqa-admin-test-icmp-echo] frequency 100
# Create reaction entry 1, specifying that five consecutive probe failures trigger the Track module.
[RouterA-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail
threshold-type consecutive 5 action-type trigger-only
[RouterA-nqa-admin-test-icmp-echo] quit
# Start the NQA test.
[RouterA] nqa schedule admin test start-time now lifetime forever
3. Configure a track entry on Router A:
# Configure track entry 1, and associate it with reaction entry 1 of the NQA test group (with the
administrator admin, and the operation tag test).
[RouterA] track 1 nqa entry admin test reaction 1
4. Configure VRRP on Router A:
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of Router A in VRRP group 1 to 110.
[RouterA-GigabitEthernet1/0/1] vrrp vrid 1 priority 110
# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[RouterA-GigabitEthernet1/0/1] vrrp vrid 1 authentication-mode simple hello
# Configure the master to send VRRP packets at an interval of 5 seconds.
[RouterA-GigabitEthernet1/0/1] vrrp vrid 1 timer advertise 5
# Configure Router A to operate in preemptive mode, and set the preemption delay to 5 seconds.
[RouterA-GigabitEthernet1/0/1] vrrp vrid 1 preempt-mode timer delay 5
# Configure to monitor track entry 1 and specify the priority decrement to 30.
[RouterA-GigabitEthernet1/0/1] vrrp vrid 1 track 1 reduced 30
5. Configure VRRP on Router B:
<RouterB> system-view
[RouterB] interface gigabitethernet 1/0/1
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[RouterB-GigabitEthernet1/0/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.
[RouterB-GigabitEthernet1/0/1] vrrp vrid 1 authentication-mode simple hello
# Configure the master to send VRRP packets at an interval of 5 seconds.
[RouterB-GigabitEthernet1/0/1] vrrp vrid 1 timer advertise 5
# Configure Router B to operate in preemptive mode, and set the preemption delay to 5 seconds.
[RouterB-GigabitEthernet1/0/1] vrrp vrid 1 preempt-mode timer delay 5
Verifying the configuration
After configuration, ping Host B on Host A, and you can see that Host B is reachable. To view the
configuration result, use the display vrrp command.
# Display detailed information about VRRP group 1 on Router A.
[RouterA-GigabitEthernet1/0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard