R3303-HP HSR6800 Routers High Availability Configuration Guide

43
user-defined port shutdown mode. To enable the port to perform DLDP detect again, you can reset the
DLDP state of the port by using one of the following methods:
• If the port is shut down with the shutdown command manually, run the undo shutdown command
on the port.
• If DLDP automatically shuts down the port, run the dldp reset command on the port to enable the
port to perform DLDP detection again. Alternatively, you can wait for DLDP to automatically enable
the port when it detects that the link has been restored to bidirectional. For information about how
to reset the DLDP state by using the dldp reset command, see "Resetting DLDP state in system view"
and "Resetting DLDP state in port view/port group view."
T
he DLDP state that the port transits to upon the DLDP state reset operation depends on its physical state.
If the port is physically down, it transits to Inactive state. If the port is physically up, it transits to Active
state.
Resetting DLDP state in system view
Resetting DLDP state in system view applies to all ports of the device.
To reset DLDP in system view:
Ste
p
Command
1. Enter system view.
system-view
2. Reset DLDP state.
dldp reset
Resetting DLDP state in port view/port group view
Resetting DLDP state in port view or port group view applies to the current port or all ports in the port
group.
To reset DLDP state in port view/port group view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Ethernet interface
view/port group view.
• Enter Ethernet
interface view:
interface
interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either method.
Configurations made in Ethernet interface
view apply to the current port only.
Configurations made in port group view
apply to all the ports in the port group.
3. Reset DLDP state.
dldp reset N/A
Displaying and maintaining DLDP