R3303-HP HSR6800 Routers High Availability Configuration Guide

61
Binding RPR physical ports with an RPR logical interface in RPR physical port view
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RPR physical
port view.
interface rprpos
interface-number
N/A
3. Bind the RPR logical
interface with the RPR
physical port.
rpr bind { rpr interface-number }
{ ringlet0 | ringlet1 }
By default, no RPR physical ports are bound
with an RPR logical interface.
Enabling RPR mate port smart connection
For an RPR station to forward traffic, before binding its two RPR physical ports with the same logical RPR
interface, you must connect their mate ports.
When the two RPR physical ports are on the same subcard, that is, in centralized RPR, you can enable
the RPR mate port smart connection function. With the function enabled, RPR automatically connects the
two mate ports without you having to connect them manually.
To enable RPR mate port smart connection:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RPR logical
interface view.
interface rpr
interface-number
N/A
3. Enable RPR mate port
smart connection.
rpr mate smart-connect Disabled by default.
Configuring the RPR station name
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RPR logical
interface view.
interface rpr interface-number N/A
3. Configure a station
name.
rpr station-name station-name No station name is configured by default.
Configuring RPR protection
Configuring the RPR protection mode
All the stations on an RPR ring must adopt the same protection mode for the ring to operate correctly.
To configure the protection mode on the RPR station: