R3303-HP HSR6800 Routers High Availability Configuration Guide

Figure 25 Network diagram

Configuration procedure

1. Configure Router A:

# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region

configuration.

<RouterA> system-view

[RouterA] vlan 1 to 30

[RouterA] stp region-configuration

[RouterA-mst-region] instance 1 vlan 1 to 30

[RouterA-mst-region] active region-configuration

[RouterA-mst-region] quit

# Set the physical state change suppression interval to 0 seconds on GigabitEthernet 3/0/1 and

GigabitEthernet 3/0/2. Disable the spanning tree feature, configure the two ports as trunk ports,

and assign them to VLANs 1 through 30.

[RouterA] interface gigabitethernet 3/0/1

[RouterA-GigabitEthernet3/0/1] link-delay 0

[RouterA-GigabitEthernet3/0/1] undo stp enable

[RouterA-GigabitEthernet3/0/1] port link-type trunk

[RouterA-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30

[RouterA-GigabitEthernet3/0/1] quit

[RouterA] interface gigabitethernet 3/0/2

[RouterA-GigabitEthernet3/0/2] link-delay 0

[RouterA-GigabitEthernet3/0/2] undo stp enable

[RouterA-GigabitEthernet3/0/2] port link-type trunk

[RouterA-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30

[RouterA-GigabitEthernet3/0/2] quit

# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1,

and configure the VLANs mapped to MSTI 1 as the protected VLANs of RRPP domain 1.

[RouterA] rrpp domain 1

[RouterA-rrpp-domain1] control-vlan 4092

[RouterA-rrpp-domain1] protected-vlan reference-instance 1

# Configure Router A as the master node of primary ring 1, with GigabitEthernet 3/0/1 as the

primary port and GigabitEthernet 3/0/2 as the secondary port, and enable ring 1.