R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

379
Use undo ospfv3 timer poll to restore the default value.
Syntax
ospfv3 timer poll seconds [ instance instance-id ]
undo ospfv3 timer poll [ seconds ] [ instance instance-id ]
Default
The poll interval is 120 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Specifies the poll interval in seconds, in the range of 1 to 65535.
instance-id: Specifies an interface instance by its ID in the range of 0 to 255. The default is 0.
Examples
# Set the poll timer interval on the current interface to 130 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-Gigabitethernet2/1/1] ospfv3 timer poll 130
ospfv3 trans-delay
Use ospfv3 trans-delay to configure the transmission delay for an interface with an instance ID.
Use undo ospfv3 trans-delay to restore the default.
Syntax
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ seconds ] [ instance instance-id ]
Default
The transmission delay is 1s.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Specifies the transmission delay in seconds, in the range of 1 to 3600.
instance-id: Specifies an instance by its ID in the range of 0 to 255. The default is 0.