R3303-HP HSR6800 Routers Layer 3 - IP Services Configuration Guide

12
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Enable proxy ARP.
proxy-arp enable Disabled by default.
Displaying and maintaining proxy ARP
Task Command Remarks
Display whether proxy ARP is
enabled.
display proxy-arp [ interface interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Proxy ARP configuration example
Network requirements
Host A and Host D have the same prefix and mask, but they are located on different subnets. No default
gateway is configured on Host A and Host D.
Configure proxy ARP on the router to enable communication between Host A and Host D.
Figure 5 Network diagram
Configuration procedure
# Configure the IP address of interface GigabitEthernet 3/0/1.
<Router> system-view
[Router] interface gigabitethernet 3/0/1