R3303-HP HSR6800 Routers MPLS Command Reference

98
Examples
# Display information about RSVP-TE RSBs.
<Sysname> display mpls rsvp-te rsb-content 19.19.19.19 1 0 29.29.29.29 101.101.101.2
The RSB Content:
Tunnel Dest: 29.29.29.29 Session Tunnel ID: 0
Tunnel ExtID: 19.19.19.19
Next Hop: 101.101.101.2 Reservation Style: SE Style
Reservation Incoming Interface: GigabitEthernet2/1/1
Reservation Interface: GigabitEthernet2/1/1
Message ID : 2
Filter Spec Information-
The filter number: 1
Ingress LSR ID: 19.19.19.19 Local LSP ID: 1 OutLabel: 3
Graceful Restart State: Stale
RRO Information-
RRO-Flag is
RRO-CType: IPV4 RRO-IPAddress: 101.101.101.2 RRO-IPPrefixLen: 32
FlowSpec Information-
Token bucket rate: 2500.00
Token bucket size: 0.00
Peak data rate: 0.00
Minimum policed unit: 0
Maximum packet size: 0
Bandwidth guarantees: 0.00
Delay guarantees: 0
Qos Service is Controlled
Resv Message arrive on GigabitEthernet2/1/1 from NHOP 101.101.101.2
Graceful Restart State: Stale
Table 41 Command output
Field Descri
p
tion
Tunnel Dest Tunnel destination, in the format of X.X.X.X.
Tunnel Ext ID
Tunnel extension (ingress LSR ID), in the format of
X.X.X.X.
Next Hop Next hop address, in the format of X.X.X.X.
Reservation Style Reservation style: SE or FF.
Reservation Interface Reservation interface name.
Reserve Incoming Interface
Incoming interface where the Resv message was
received.
Message ID Message ID of the Refresh Reduction message.
Filter Spec Information Filter specifications.
The filter number Number of filters.
Ingress LSR ID Ingress LSR ID, in the format of X.X.X.X.
Out Label Outgoing label.