R3303-HP HSR6800 Routers MPLS Command Reference

224
You cannot change an RD directly. You can only delete the VPN and then re-create the VPN by using the
new RD.
Examples
# Configure the RD of a VPN.
<Sysname> system-view
[Sysname] mpls l2vpn vpn1 encapsulation ppp
[Sysname-mpls-l2vpn-vpn1] route-distinguisher 300:1
service-instance
Use service-instance to create a service instance on the current interface and enter service instance view.
Use undo service-instance to delete a service instance on the current interface.
Syntax
service-instance instance-id
undo service-instance instance-id
Default
No service instances have been created on any interface.
Views
Interface view
Default command level
2: System level
Parameters
instance-id: Specifies a service instance ID in the range of 1 to 4096.
Usage guidelines
This command is supported only on routers with SAP-4EXPs.
The device can support up to 20480 service instances.
Examples
# Create service instance 1 on Ten-GigabitEthernet 1/0/1, and then enter service instance view.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] service-instance 1
[Sysname-Ten-GigabitEthernet1/0/1-srv1]
static backup-label
Use static backup-label to configure VC labels for a backup VC.
Use undo static backup-label to remove the VC labels configured for the backup VC.
Syntax
static backup-label local local-vc remote remote-vc
undo static backup-label