R3303-HP HSR6800 Routers MPLS Command Reference

232
Default command level
2: System level
Usage guidelines
This command is supported only on routers with SAP-4EXPs.
This command applies only to VCs created by using the xconnect static-peer command in service
instance view.
You can use this command to manage traffic on the network.
After you execute this command, if the VC has an available primary or backup VC, the device switches
traffic from the VC to the primary or backup VC. Otherwise, the device does not switch traffic.
Example
# Assume that a primary static VC and a backup static VC are established for service instance 10. Switch
traffic from the currently active VC to the standby VC.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] service-instance 10
[Sysname-Ten-GigabitEthernet1/0/2-srv10] xconnect static-peer switchover