R3303-HP HSR6800 Routers MPLS Command Reference

255
Parameters
vsi-name: Specifies the name of the VPLS instance, a case-insensitive string of 1 to 31 characters.
Hyphens (-) are not allowed.
access-mode: Specifies the access mode of the VPLS instance, which can be ethernet or vlan. If the
interface bound with the VPLS instance is a Layer 3 Ethernet subinterface, the default access mode is vlan;
otherwise, the default access mode is ethernet.
ethernet: Specifies the access mode of Ethernet.
vlan: Specifies the access mode of VLAN.
Usage guidelines
IMPORTANT:
W
ith the l2 binding vsi command configured on an interface, services bound to the interface are
considered the internal VPN services of the VPLS instance.
The device does not support binding a VPLS instance to a VLAN interface.
Examples
# Bind VPLS instance aaa to interface GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] l2 binding vsi aaa
Related commands
• peer
• vsi
mac-learning
Use mac-learning to enable or disable MAC address learning for a VPLS instance.
Syntax
mac-learning { enable | disable }
Default
MAC address learning is enabled.
Views
VSI view
Default command level
2: System level
Parameters
enable: Enables MAC address learning for the VPLS instance.
disable: Disables MAC address learning for the VPLS instance.
Usage guidelines
With MAC address learning disabled for a VPLS instance, the system does not learn source MAC
addresses from the packets received from the VPLS instance.