R3303-HP HSR6800 Routers MPLS Command Reference

73
Related commands
• display mpls statistics lsp in-label
• display mpls statistics tunnel
statistics interval
Use statistics interval to set the interval for reading collected statistics.
Use undo statistics interval to restore the default.
Syntax
statistics interval interval-time
undo statistics interval
Default
The LSP statistics reading interval is 0, which indicates that the system does not read collected LSP
statistics.
Views
MPLS view
Default command level
2: System level
Parameters
interval-time: Specifies the statistics reading interval in the range of 30 to 65535 seconds.
Examples
# Set the LSP statistics reading interval to 30 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] statistics interval 30
Related commands
• display mpls statistics interface
• display mpls statistics lsp
tracert lsp ipv4
Use tracert lsp ipv4 to locate errors on the LSP for a FEC.
Syntax
tracert lsp [ -a source-ip | -exp exp-value | -h ttl-value | -r reply-mode | -t time-out ] * ipv4 dest-addr
mask-length [ destination-ip-addr-header ]
Views
Any view
Default command level
0: Visit level