R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

139
Configuring NetStream aggregation data export
Configurations in NetStream aggregation view apply to aggregation data export only, and those in
system view apply to NetStream traditional data export. If configurations in NetStream aggregation view
are not provided, the configurations in system view apply to the aggregation data export.
To configure NetStream aggregation data export:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable NetStream.
ip netstream { inbound | outbound } Disabled by default.
4. Exit to system view.
quit N/A
5. Set a NetStream
aggregation mode and
enter its view.
ip netstream aggregation { as |
destination-prefix | prefix | prefix-port
| protocol-port | source-prefix | tos-as
| tos-destination-prefix | tos-prefix |
tos-protocol-port | tos-source-prefix |
tos-bgp-nexthop }
N/A
6. Configure the destination
address and the
destination UDP port
number for the NetStream
aggregation data export.
ip netstream export host ip-address
udp-port [ vpn-instance
vpn-instance-name ]
By default, no destination
address or destination UDP port
number is configured in
NetStream aggregation view.
If you expect to export only
NetStream aggregation data,
configure the destination address
in related aggregation view only.
7. Configure the source
interface for NetStream
aggregation data export.
ip netstream export source interface
interface-type interface-number
Optional.
By default, the interface
connecting to the NetStream
server is used as the source
interface.
• Source interfaces in different
aggregation views can be
different.
• If no source interface is
configured in aggregation
view, the source interface
configured in system view, if
any, is used.
• HP recommends that you
connect the network
management interface to the
NetStream server.
8. Enable the NetStream
aggregation
configuration.
enable Disabled by default.