R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

165
Outputting system information to the monitor
terminal
Monitor terminals refer to terminals that log in to the device through the AUX, VTY, or TTY user interface.
To output system information to the monitor terminal:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the information
center.
info-center enable
Optional.
Enabled by default.
3. Name the channel
with a specified
channel number.
info-center channel channel-number name
channel-name
Optional.
See Table 7 for
default channel
names.
4. Configure an output
channel for the monitor
terminal.
info-center monitor channel
{ channel-number | channel-name }
Optional.
By default, system information is
output to the monitor terminal
through channel 1 (known as
monitor).
5. Configure an output
rule for the monitor
terminal.
info-center source { module-name |
default } channel { channel-number |
channel-name } [ debug { level severity |
state state } * | log { level severity | state
state } * | trap { level severity | state
state } * ] *
Optional.
See "Default output rules of system
informati
on."
6. Configure the
timestamp format.
info-center timestamp { debugging | log |
trap } { boot | date | none }
Optional.
By default, the timestamp format
for log, trap and debugging
information is date.
7. Return to user view.
quit N/A
8. Enable system
information output to
the monitor terminal.
terminal monitor
The default setting is disabled.
You must first execute this
command, and then you can
enable the display of debugging,
log, and trap information on the
monitor terminal.
9. Enable the display of
system information on
the monitor terminal.
• Enable the display of debugging
information on the monitor terminal:
terminal debugging
• Enable the display of log information
on the monitor terminal:
terminal logging
• Enable the display of trap information
on the monitor terminal:
terminal trapping
Optional.
By default, the monitor terminal
displays log and trap information,
and discards debug information.