R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

11
NQA configuration task list
Complete the following task to configure the NQA server:
Task Remarks
Configuring the NQA server
Required for NQA operations types of TCP, UDP echo, UDP
jitter, and voice.
Complete these tasks to configure the NQA client:
Task Remarks
Enabling the NQA client Required.
Configuring an ICMP echo operation
Required.
Use at least one method.
Configuring a DHCP operation
Configuring a DNS operation
Configuring an FTP operation
Configuring an HTTP operation
Configuring a UDP jitter operation
Configuring an SNMP operation
Configuring a TCP operation
Configuring a UDP echo operation
Configuring a voice operation
Configuring a DLSw operation
Configuring optional parameters for an NQA operation Optional.
Configuring the collaboration function Optional.
Configuring threshold monitoring Optional.
Configuring the NQA statistics function Optional.
Configuring NQA history records saving function Optional.
Scheduling an NQA operation Required.
Configuring the NQA server
To perform TCP, UDP echo, UDP jitter, and voice operations, you must enable the NQA server on the
destination device. The NQA server listens and responds to requests on the specified IP addresses and
ports.
You can configure multiple TCP (or UDP) listening services on an NQA server, each of which corresponds
to a specific destination IP address and port number. The destination IP address and port number must
be the same as those configured on the NQA client and must be different from those of an existing
listening service.