R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

189
Figure 65 Network diagram
Configuration procedure
1. Configure the router.
# Enable gateway mode.
[HP]gateway-mode
Info: Please reboot the device to make the configuration take effect.
# Reboot the router.
2. Display device information to check if the router is in gateway mode.
<HP>display device
System-mode(Current/After Reboot): Gateway/Gateway
Slot No. Board type Status Primary SubSlots
--------------------------------------------------------------
0 HSR6602-XG Normal Master 0
1 FIP-10 Normal N/A 4
The output shows that the router is operating in gateway mode.
3. Configure routing and NAT.
The configuration commands and procedures in gateway mode are the same as those in normal
mode, and are not shown.