R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

22
Ste
p
Command Remarks
8. Specify the source IP address
of voice packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up.
Otherwise, no voice packets can
be sent out.
9. Specify the source port
number of voice packets.
source port port-number
Optional.
By default, no source port number
is specified.
10. Configure the payload size in
each voice packet.
data-size size
Optional.
By default, the voice packet size
depends on the codec type. The
default packet size is 172 bytes for
G.711A-law and G.711 μ-law
codec type, and 32 bytes for
G.729 A-law codec type.
11. Configure the string to be
filled in the payload of each
voice packet.
data-fill string
Optional.
By default, the string is the
hexadecimal number
00010203040506070809.
12. Configure the number of voice
packets to be sent in a voice
probe.
probe packet-number
packet-number
Optional.
1000 by default.
13. Configure the interval for
sending voice packets.
probe packet-interval
packet-interval
Optional.
20 milliseconds by default.
14. Configure how long the NQA
client waits for a response
from the server before it
regards the response times
out.
probe packet-timeout
packet-timeout
Optional.
5000 milliseconds by default.
NOTE:
The display nqa history command cannot show the results of the voice operation. Use the display nqa
result command to display the results, or use the display nqa statistics command to display the statistics of
the operation.
Configuring a DLSw operation
A DLSw operation measures the response time of a DLSw device.
To configure a DLSw operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A