R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

24
Ste
p
Command Remarks
5. Specify the interval at which
the NQA operation repeats.
frequency interval
Optional.
By default, the interval is 0
milliseconds. Only one operation
is performed.
If the operation is not completed
when the interval expires, the next
operation does not start.
6. Specify the probe times.
probe count times
Optional.
By default, an NQA operation
performs one probe.
The voice operation can perform
only one probe, and does not
support this command.
7. Specify the probe timeout
time.
probe timeout timeout
Optional.
By default, the timeout time is 3000
milliseconds.
This setting is not available for the
UDP jitter or voice operation.
8. Specify the TTL for probe
packets.
ttl value
Optional.
20 by default.
This setting is not available for the
DHCP operation.
9. Specify the ToS value in the IP
packet header of probe
packets.
tos value
Optional.
0 by default.
This setting is not available for the
DHCP operation.
10. Enable the routing table
bypass function.
route-option bypass-route
Optional.
Disabled by default.
This setting is not available for the
DHCP operation.
Configuring the collaboration function
Collaboration is implemented by associating a reaction entry of an NQA operation with a track entry.
The reaction entry monitors the NQA operation. If the number of operation failures reaches the specified
threshold, the configured action is performed.
Before you configure a reaction entry for the trigger and trap action, configure the destination address of
the trap messages by using the snmp-agent target-host command. For more information about the
command, see Network Management and Monitoring Command Reference.
To configure the collaboration function:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A