R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

25
Ste
p
Command Remarks
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operation is
created.
3. Specify an NQA operation
type and enter its view.
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo }
The collaboration function is not
available for the UDP jitter and
voice operations.
4. Configure a reaction entry.
• The trigger action only:
reaction item-number
checked-element probe-fail
threshold-type consecutive
consecutive-occurrences
action-type trigger-only
• The trigger and trap action:
reaction item-number
checked-element probe-fail
threshold-type consecutive
consecutive-occurrences
action-type trap-and-trigger
Not configured by default.
The trigger-only keyword is not
supported by the UDP jitter or voice
operation.
The trap-and-trigger keyword is
not supported by the DNS, UDP
jitter, or voice operation.
You cannot modify the content of
an existing reaction entry. To
change the attributes in a reaction
entry, use the undo reaction
command to delete the entry first
and then configure a new one.
5. Exit to system view.
quit N/A
6. Associate Track with NQA.
See High Availability
Configuration Guide.
N/A
7. Associate Track with an
application module.
See High Availability
Configuration Guide.
N/A
Configuring threshold monitoring
Introduction
1. Threshold types
An NQA operation supports the following threshold types:
{ average—If the average value for the monitored performance metric either exceeds the upper
threshold or goes below the lower threshold, a threshold violation occurs.
{ accumulate—If the total number of times that the monitored performance metric is out of the
specified value range reaches or exceeds the specified threshold, a threshold violation occurs.
{ consecutive—If the number of consecutive times that the monitored performance metric is out of
the specified value range reaches or exceeds the specified threshold, a threshold violation
occurs.
Threshold violations for the average or accumulate threshold type are determined on a per NQA
operation basis, and threshold violations for the consecutive type are determined from the time the
NQA operation starts.
2. Triggered actions
The following actions might be triggered:
{ none—NQA displays results only on the terminal screen. It does not send traps to the NMS.