R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

# Enable the SNMP agent, and set the SNMP version to all, the read community to public, and the

write community to private.

<RouterB> system-view

[RouterB] snmp-agent sys-info version all

[RouterB] snmp-agent community read public

[RouterB] snmp-agent community write private

4. Configure Router A:

# Create an SNMP operation and configure 10.2.2.2 as the destination IP address.

<RouterA> system-view

[RouterA] nqa entry admin test1

[RouterA-nqa-admin-test1] type snmp

[RouterA-nqa-admin-test1-snmp] destination ip 10.2.2.2

# Enable the saving of history records.

[RouterA-nqa-admin-test1-snmp] history-record enable

[RouterA-nqa-admin-test1-snmp] quit

# Start the SNMP operation.

[RouterA] nqa schedule admin test1 start-time now lifetime forever

# Stop the SNMP operation after a period of time.

[RouterA] undo nqa schedule admin test1

# Display the results of the SNMP operation.

[RouterA] display nqa result admin test1

NQA entry (admin admin, tag test1) test results:

Destination IP address: 10.2.2.2

Send operation times: 1 Receive response times: 1

Min/Max/Average round trip time: 50/50/50

Square-Sum of round trip time: 2500

Last succeeded probe time: 2011-11-22 10:24:41.1

Extended results:

Packet loss in test: 0%

Failures due to timeout: 0

Failures due to disconnect: 0

Failures due to no connection: 0

Failures due to sequence error: 0

Failures due to internal error: 0

Failures due to other errors: 0

Packet(s) arrived late: 0

# Display the history records of the SNMP operation.

[RouterA] display nqa history admin test1

NQA entry (admin admin, tag test1) history record(s):

Index Response Status Time

1 50 Timeout 2011-11-22 10:24:41.1

The output shows that Router A uses 50 milliseconds to receive a response from the SNMP agent.