R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide
65
Ste
p
Command
Remarks
2. Enable NTP authentication.
ntp-service authentication enable
By default, NTP authentication is
disabled.
3. Configure an NTP
authentication key.
ntp-service authentication-keyid
keyid authentication-mode md5
[ cipher | simple ] value
By default, no NTP authentication
key is configured.
Configure the same authentication
key on the active symmetric peer
and passive symmetric peer.
4. Configure the key as a trusted
key.
ntp-service reliable
authentication-keyid keyid
By default, no authentication key is
configured to be trusted.
5. Associate the specified key
with the passive peer.
ntp-service unicast-peer
{ ip-address | peer-name }
authentication-keyid keyid
You can associate a non-existing
key with a passive peer. To enable
NTP authentication, you must
configure the key and specify it as
a trusted key after associating the
key with the passive peer.
Configuring NTP authentication for a passive peer
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enable NTP authentication.
ntp-service authentication enable
By default, NTP authentication is
disabled.
3. Configure an NTP
authentication key.
ntp-service authentication-keyid
keyid authentication-mode md5
[ cipher | simple ] value
By default, no NTP authentication
key is configured.
Configure the same authentication
key on the active symmetric peer
and passive symmetric peer.
4. Configure the key as a trusted
key.
ntp-service reliable
authentication-keyid keyid
By default, no authentication key is
configured to be trusted.
Configuring NTP authentication in broadcast mode
Follow these instructions to configure NTP authentication in broadcast mode:
• A broadcast client can synchronize to the broadcast server only when you configure all the required
tasks on both the broadcast client and server.
• If NTP authentication is not enabled on the client, the broadcast client can synchronize to the
broadcast server no matter whether NTP authentication is enabled or not on the server.
Configuring NTP authentication for a broadcast client
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A