R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide
66
Ste
p
Command
Remarks
2. Enable NTP authentication.
ntp-service authentication enable
By default, NTP authentication is
disabled.
3. Configure an NTP
authentication key.
ntp-service authentication-keyid
keyid authentication-mode md5
[ cipher | simple ] value
By default, no NTP authentication
key is configured.
Configure the same authentication
key on the client and server.
4. Configure the key as a trusted
key.
ntp-service reliable
authentication-keyid keyid
By default, no authentication key is
configured to be trusted.
Configuring NTP authentication for a broadcast server
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enable NTP authentication.
ntp-service authentication enable
By default, NTP authentication is
disabled.
3. Configure an NTP
authentication key.
ntp-service authentication-keyid
keyid authentication-mode md5
[ cipher | simple ] value
By default, no NTP authentication
key is configured.
Configure the same authentication
key on the client and server.
4. Configure the key as a trusted
key.
ntp-service reliable
authentication-keyid keyid
By default, no authentication key is
configured to be trusted.
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Associate the specified key
with the broadcast server.
ntp-service broadcast-server
authentication-keyid keyid
You can associate a non-existing
key with the broadcast server. To
enable NTP authentication, you
must configure the key and specify
it as a trusted key after associating
the key with the broadcast server.
Configuring NTP authentication in multicast mode
Follow these instructions to configure NTP authentication in multicast mode:
• A broadcast client can synchronize to the broadcast server only when you configure all the required
tasks on both the broadcast client and server.
• If NTP authentication is not enabled on the client, the multicast client can synchronize to the
multicast server no matter whether NTP authentication is enabled on the server.
Configuring NTP authentication for a multicast client
Ste
p
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enable NTP authentication.
ntp-service authentication enable
By default, NTP authentication is
disabled.