R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

89
Ste
p
Command Remarks
5. Create or update a MIB view.
snmp-agent mib-view { excluded |
included } view-name oid-tree
[ mask mask-value ]
Optional.
By default, the MIB view
ViewDefault is predefined and its
OID is 1.
Each view-name oid-tree pair
represents a view record. If you
specify the same record with
different MIB subtree masks
multiple times, the last
configuration takes effect. Except
the four subtrees in the default MIB
view, you can create up to 16
unique MIB view records.
6. Configure an SNMPv3 group.
snmp-agent group v3 group-name
[ authentication | privacy ]
[ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ] [ acl
acl-number | acl ipv6
ipv6-acl-number ] *
By default, no SNMP group exists.
7. Convert a plaintext key to a
ciphertext (encrypted) key.
snmp-agent calculate-password
plain-password mode { 3desmd5 |
3dessha | md5 | sha }
{ local-engineid |
specified-engineid engineid }
Optional.
8. Add a user to the SNMPv3
group.
snmp-agent usm-user v3
user-name group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode
{ 3des | aes128 | des56 }
priv-password ] ] [ acl acl-number |
acl ipv6 ipv6-acl-number ] *
The md5, des56, and 3des
keywords are supported only in
non-FIPS mode.
9. Configure the maximum
SNMP packet size (in bytes)
that the SNMP agent can
handle.
snmp-agent packet max-size
byte-count
Optional.
By default, the SNMP agent can
receive and send SNMP packets
up to 1500 bytes.
Configuring SNMPv1 or SNMPv2c basic parameters
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the SNMP
agent.
snmp-agent
Optional.
By default, the SNMP agent is
disabled.
You can also enable the SNMP agent
by using any command that begins
with snmp-agent.