R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

90
Ste
p
Command Remarks
3. Configure system
information for the
SNMP agent.
snmp-agent sys-info { contact sys-contact
| location sys-location | version { all |
{ v1 | v2c | v3 }* } }
The defaults are as follows:
• Contact—Null.
• Location—Null.
• Version—SNMPv3.
4. Configure the local
engine ID.
snmp-agent local-engineid engineid
Optional.
The default local engine ID is the
company ID plus the device ID.
5. Create or update a
MIB view.
snmp-agent mib-view { excluded |
included } view-name oid-tree [ mask
mask-value ]
Optional.
By default, the MIB view ViewDefault
is predefined and its OID is 1.
Each view-name oid-tree pair
represents a view record. If you
specify the same record with different
MIB subtree masks multiple times, the
last configuration takes effect. Except
the four subtrees in the default MIB
view, you can create up to 16 unique
MIB view records.
6. Configure the SNMP
access right.
• (Method 1) Create an SNMP
community:
snmp-agent community { read |
write } [ cipher ] community-name
[ mib-view view-name ] [ acl
acl-number | acl ipv6
ipv6-acl-number ] *
• (Method 2) Create an SNMP group,
and add a user to the SNMP group:
a. snmp-agent group { v1 | v2c }
group-name [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number |
acl ipv6 ipv6-acl-number ] *
b. snmp-agent usm-user { v1 |
v2c } user-name group-name [ acl
acl-number | acl ipv6
ipv6-acl-number ] *
Use either method.
By default, no SNMP group exists.
The username configured by using
method 2 is equivalent to the
community name configured by using
method 1, and it must be the same as
the community name configured on
the NMS.
7. Configure the
maximum size (in
bytes) of SNMP
packets for the
SNMP agent.
snmp-agent packet max-size byte-count
Optional.
By default, the SNMP agent can
receive and send SNMP packets up
to 1500 bytes.
Configuring SNMP logging