5.5 HP StorageWorks X9300 Network Storage Gateway Administrator Guide (AW539-96007, March 2011)
Table Of Contents
- X9300 Network Storage Gateway Administrator Guide
- Contents
- 1 Product description
- 2 Getting started
- 3 Configuring virtual interfaces for client access
- 4 Configuring failover
- 5 Configuring cluster event notification
- 6 Configuring system backups
- 7 Creating hostgroups for X9000 clients
- 8 Monitoring cluster operations
- 9 Maintaining the system
- Shutting down the system
- Starting the system
- Powering file serving nodes on or off
- Starting and stopping processes
- Tuning file serving nodes and X9000 clients
- Migrating segments
- Removing storage from the cluster
- Maintaining networks
- Viewing network interface information
- 10 Migrating to an agile managment console configuration
- 11 Upgrading the X9000 Software
- 12 Licensing
- 13 Upgrading firmware
- 14 Troubleshooting
- 15 Replacing components
- 16 Recovering a file serving node
- 17 Support and other resources
- A Component and cabling diagrams
- B Spare parts list
- C Warnings and precautions
- D Regulatory compliance and safety
- Glossary
- Index
Safety
Battery Replacement notice
WARNING!
The computer contains an internal lithium manganese dioxide, a vanadium pentoxide, or an alkaline
battery pack. A risk of fire and burns exists if the battery pack is not properly handled. To reduce the
risk of personal injury:
• Do not attempt to recharge the battery.
• Do not expose the battery to temperatures higher than 60˚C (140˚F).
• Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
Batteries, battery packs, and accumulators should not be disposed of together with the general
household waste. To forward them to recycling or proper disposal, please use the public collection
system or return them to HP, an authorized HP Partner, or their agents.
For more information about battery replacement or proper disposal, contact an authorized reseller
or an authorized service provider.
Taiwan Battery Recycling Notice
The Taiwan EPA requires dry battery manufacturing or importing firms in
accordance with Article 15 of the Waste Disposal Act to indicate the recovery marks on the batteries
used in sales, giveaway or promotion. Contact a qualified Taiwanese recycler for proper battery
disposal.
Power cords
The power cord set must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another country, purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage and current marked on the product
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage
and current rating marked on the product. In addition, the diameter of the wire must be a minimum
of 1.00 mm2 or 18 AWG, and the length of the cord must be between 1.8 m (6 ft) and 3.6 m (12
ft). If you have questions about the type of power cord to use, contact an HP-authorized service
provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items placed upon
or against them. Pay particular attention to the plug, electrical outlet, and the point where the cords
exit from the product.
X9300 Network Storage Gateway Administrator Guide 147