6.3 HP StoreAll 9300/9320 Storage Administrator Guide (AW549-96072, June 2013)

IMPORTANT: You must compile and manually register the StoreAll MIB file by using HP Systems

Insight Manager:

1. Download ibrixMib.txt from /usr/local/ibrix/doc/.

2. Rename the file to ibrixMib.mib.

3. In HP Systems Insight Manager, complete the following steps:

a. Unregister the existing MIB by entering the following command:

<BASE>\mibs>mxmib -d ibrixMib.mib

b. Copy the ibrixMib.mib file to the <BASE>\mibs directory, and then enter the following

commands:

<BASE>\mibs>mcompile ibrixMib.mib

<BASE>\mibs>mxmib -a ibrixMib.cfg

For more information about the MIB, see the "Compiling and customizing MIBs" chapter in the HP

Systems Insight Manager User Guide, which is available at:

http://www.hp.com/go/insightmanagement/sim/

Click Support & Documents and then click Manuals. Navigate to the user guide.

Limitations

Note the following:

• For StoreAll systems, the HP Insight Remote Support implementation is limited to hardware

events.

Configuring the StoreAll cluster for Insight Remote Support

To enable 9300/9320 systems for remote support, first register MSA disk arrays and then configure

Phone Home settings. All nodes in the cluster should be up when you perform this step.

NOTE: Configuring Phone Home removes any previous StoreAll snmp configuration details and

populates the SNMP configuration with Phone Home configuration details. When Phone Home is

enabled, you cannot use ibrix_snmpagent to edit or change the snmp agent configuration.

However, you can use ibrix_snmptrap to add trapsink IPs and you can use ibrix_event to

associate events to the trapsink IPs.

Registering MSA disk arrays

To register an MSA disk array with the cluster, run the following command:

# ibrix_vs -r -n STORAGENAME -t msa -I IP(s) -U USERNAME [-P PASSWORD]

Configuring Phone Home settings

To configure Phone Home on the GUI, select Cluster Configuration in the upper Navigator and

then select Phone Home in the lower Navigator. The Phone Home Setup panel shows the current

configuration.

36 Getting started