6.3 HP StoreAll 9300/9320 Storage Administrator Guide (AW549-96072, June 2013)

3. Highlight the BIOS Serial Console & EMS option in main menu, and then press the Enter key.
Highlight the BIOS Serial Console Port option and then press the Enter key. Select the COM1
port, and then press the Enter key.
4. Highlight the BIOS Serial Console Baud Rate option, and then press the Enter key. Select the
115200 Serial Baud Rate.
5. Highlight the Server Availability option in main menu, and then press the Enter key. Highlight
the ASR Timeout option and then press the Enter key. Select the 30 Minutes, and then press
the Enter key.
6. To exit RBSU, press Esc until the main menu is displayed. Then, at the main menu, press F10.
The server automatically restarts.
Setting up nodes for crash capture
IMPORTANT: Complete the steps in “Prerequisites for setting up the crash capture” (page 67)
before starting the steps in this section.
To set up nodes for crash capture, complete the following steps:
1. Enable crash capture. Run the following command:
ibrix_host_tune -S { -h HOSTLIST | -g GROUPLIST } -o
trigger_crash_on_failover=1
2. Tune Fusion Manager to set the DUMPING status timeout by entering the following command:
ibrix_fm_tune -S -o dumpingStatusTimeout=240
This command is required to delay the failover until the crash kernel is loaded; otherwise,
Fusion Manager will bring down the failed node.
68 Configuring failover