HP Intelligent Management Center v5.2 Application Performance Manager Administrator Guide

472
selected. APM automatically adds the dependencies between URL and operating system
applications by IP address and displays their dependencies in the application topology. To
remove dependencies between URL and one or more applications, select the target
applications in the Related Applications box and click Delete.
 Detect Application—Select this parameter if you want to enable application detection.
Application detection enables APM to verify connection to the application by using the previous
parameter settings, and to determine whether to modify the application monitor based on the
verification result. APM modifies the application monitor only when it can connect to the
application. If you do not select this parameter, APM modifies the application monitor without
verifying the connection.
5. Click OK.
Viewing the URL application monitor report
After you add a URL application monitor, APM starts collecting index data of the application to calculate
its availability and health status. Operators can obtain monitor indexes of the URL by viewing the monitor
report.
To access the URL application monitor report:
1. Click the Resource tab.
2. Select Application Manager > Application Monitor from the navigation tree.
The application monitor list page displays all application monitors.
3. Click the name link of a URL application monitor.
The URL monitor report appears, as shown in Figure 394. For information about the icons in the
monitor report, see "2 Quick start." This section describes the fields in each area of the monitor
report.
Figure 394 Part of a URL application monitor report