HP Intelligent Management Center v5.2 Application Performance Manager Administrator Guide

368
selected. APM automatically adds the dependencies between POP3 and operating system
applications by IP address and displays their dependencies in the application topology. To
remove dependencies between POP3 and one or more applications, select the target
applications in the Related Applications box and click Delete.
 Detect Application—Select this parameter if you want to enable detection as needed.
Application detection enables APM to verify connection to the application by using the previous
parameter settings, and to determine whether to modify the application monitor based on the
verification result. APM modifies the application monitor only when it can connect to the
application. When this parameter is not selected, APM modifies the application monitor without
verifying the connection.
5. Click OK.
Viewing the POP3 application monitor report
After adding a POP3 application monitor, APM collects index data of the application to calculate its
availability and health status. Obtain monitor indexes for POP3 by viewing the monitor report.
To access the POP3 application monitor report:
1. Click the Resource tab.
2. Select Application Manager > Application Monitor from the navigation tree.
The application monitor list page displays all application monitors.
3. Click the link naming the desired POP3 application monitor.
The POP3 monitor report appears, as shown in Figure 313. For information about the icons in the
monitor report, see "2 Quick start." This section describes the fields in each area of the monitor
report.
Figure 313 Part of a POP3 application monitor report
Monitor Information
The Monitor Information area layout is shown in Figure 314.