HP Intelligent Management Center v5.2 Application Performance Manager Administrator Guide

43
 Modify—Click the Modify icon to modify default port settings for the application type.
4. Click Refresh to refresh the application default port list.
5. Click Back to return to the Configurations page.
Modifying the application default port list
To modify the default ports of an application type:
1. Click the Resource tab.
2. Select Application Manager > Configurations from the navigation tree.
The Configurations page appears.
3. Click Port Configuration.
The Default Configuration list appears.
4. Click the Modify icon for the application type for which you want to modify the default ports.
5. Modify the following parameters:
 Application Type—Cannot be modified.
 Application Monitor Port—Modify the default port value that identifies the application type in
Auto Discovery.
 Traffic Collection Port—Modify the default port value for traffic collection. For information about
the application types for which you can modify the default traffic collection ports, see Table 6.
6. Click OK.
The modification has no effect on the applications already monitored.
Probe Configuration
To collect traffic of applications, you must configure probes for APM to use. When no probes are
configured or all probes are deleted, APM stops collecting application traffic and all application monitor
reports no longer contain the application traffic area.
For operating system applications, probes identify their traffic by IP address. For other applications,
probes identify their traffic by the combination of IP address and traffic collection port.
Probes must be installed and run on Linux. For more information about installing and configuring probes,
see Probe Installation Guide.
Viewing the probe list
1. Click the Resource tab.
2. Select Application Manager > Configurations from the navigation tree.
The Configurations page appears.
3. Click Probe Configuration.
The Probe List appears.
Probe list contents
 Name—Name of the probe. Click the name to view its details.
 IP Address—IP address of the probe.
 Description—Description of the probe.