Manualshelf

HP Intelligent Management Center v5.2 Application Performance Manager Administrator Guide

ManualsBrandsHP ManualsComputer AccessoriesHP IMC Application Performance Manager Software Module Additional 25-monitor QTY E-LTU
151152153154155156157158159160
148
I/O State
APM can monitor the I/O status of the disk drivers in the OpenBSD system, as shown in Figure 100.
Figure 100 I/O State area layout
I/O State area fields:
Device Name—Name of the disk drivers in the OpenBSD system.
I/O Rate—Size of the input/output data in the disk driver per second.
IOs/Sec—Number of the transfer times in the disk driver per second. A transfer is an I/O request
to the physical disk. Multiple logical requests can be integrated into a single I/O request. The size
of the transferred data in each transfer is not fixed.
HP-UX
HP-UX's performance and stability affects the performance of applications running on it. APM provides
the ability to monitor HP-UX 11.00 or later versions of the operating system.
Adding an HP-UX application monitor
APM monitors HP-UX operating system through CLI. When you add application monitors for HP-UX,
follow these guidelines:
Enable Telnet or SSH on HP-UX. For more information, see the HP-UX configuration guide.
Obtain the correct username and password of the Telnet or SSH user who has the HP-UX
administrator's privileges
To view traffic statistics in the monitor report of the HP-UX application, make sure at least one probe
is configured in APM. After an HP-UX application monitor is added, APM sends the IP address of
the monitored HP-UX application to the probes for traffic collection.
To add an HP-UX application monitor:
1. Click the Resource tab.
2. Enter the Add Application page in one of the following ways:
Select Application Manager > Add Application from the navigation tree.
The page displays all application types that can be monitored by APM.
Select Application Manager > Application Monitor from the navigation tree, and then click Add
on the application monitor list page.
3. Click HP-UX of the UNIX Server Monitor class.
The page for adding an HP-UX application monitor appears.
4. Configure the following parameters:
IP Address—Enter the IP address of the host on which the HP-UX application to be monitored is
installed. If the host is already added to the IMC Platform, you can also click Select and select