HP Intelligent Management Center v5.2 Branch Intelligent Management System Administrator Guide

To view the Alarm Notification page:
• Click Alarm > CPE > Alarm Notification.
The Alarm Notification page appears, as shown in Figure 35.
Figure 35 Alarm Notification page
From this page, you can view the three main notification methods:
• Mail Notification
• Message Notification
• Alarm Forwarding
From this page, you can access the following information for each notification rule:
• Rule Name—The names of existing notification rules.
• Status—The status (enabled or disabled) of a notification rule.
• Destination Mail Address—The mail address of the designated recipients.
• Phone Number—The phone number of the designated recipients.
• Destination Address/Port—The IP address and port information of the target server.
From this page, you can:
• Enable or disable a notification rule
• Navigate to the page of the configuring mail server
• Navigate to the page for configuring Short Message Service Center (SMSC)
• Navigate to the page for adding or modifying a notification rule
• Delete a notification rule
• Navigate to the page for copying a notification rule
• Refresh the alarm notification rules
Managing mail notifications
The mail notification function enables the system to inform the operator of an alarm by e-mail.
Configuring the mail server
A mail server must be configured to enable the system to send alarm notifications by email.
NOTE: The mail authentication configuration of the system must be consistent with that of the
server. If you have enabled authentication on the server for sending an email, you must also enable
it on the mail server in the system. If not, you will not have authentication options on the mail server.
Managing alarms notification 111