HP Intelligent Management Center v5.2 Branch Intelligent Management System Administrator Guide

5. Click OK to launch the importing process.
The CPE Importing Results page appears, where you can check the import results.
6. Click Back to end the importing process.
Configuring CPEs in batches
You can use the Batch Operate function to configure CPE parameters in batches, which avoids
accessing the CPE details page to do the configurations one by one.
Configuring the inform interval
This function enables you to set the interval at which the system polls the specified CPEs. The system
reads the configuration of the specified CPEs at the interval, and updates the system database.
To configure the inform interval in batches:
1. Click Service > BIMS > Resource Management > Batch Operate.
2. On the Batch Operate page, click Configure Inform Interval.
3. On the Periodic Inform Interval page, click Select CPE.
4. On the Select CPE List page, select the target CPEs, and then click OK.
5. Specify an Inform interval for all target CPEs, and then click Apply.
With periodic inform enabled, the inform interval (an integer in seconds) is the interval at
which the CPE tries to connect to the ACS and invokes the inform method.
Configuring the polling interval
To configure the polling interval in batches:
1. Click Service > BIMS > Resource Management > Batch Operate.
2. On the Batch Operate page, click Configure Polling Interval.
3. On the Configure Polling Interval page, click Select CPE.
4. On the Select CPE List page, select the target CPEs, and then click OK.
5. Specify an Status Polling Interval and Configuration Polling Interval for all target CPEs, and
then click Apply.
With periodic inform enabled, the inform interval (an integer in seconds) is the interval at
which the CPE tries to connect to the ACS and invokes the inform method.
Configuring access parameters
To configure the access parameters in batches:
1. Click Service > BIMS > Resource Management > Batch Operate.
2. On the Batch Operate page, click Configure Access Parameters.
3. On the Configure Access Parameters page, click Select CPE.
4. On the CPE List page, select the target CPEs, and then click OK.
5. Specify the Connection Request Username and Connection Request Password for all target
CPEs, and then click Apply.
The Connection Request Username and Connection Request Password are used to initiate a
connection request to the CPE from the ACS. The password read from CPEs is a null string
rather than the actual value.
Configuring the file transfer type
This function helps you modify the protocol to HTTP or HTTPS. It is used for transferring files between
the specified CPE and the BIMS server. The default protocol is HTTP.
To configure the file transfer type in batches:
42 Resource management