HP Intelligent Management Center v5.2 Branch Intelligent Management System Administrator Guide

• Click Service > BIMS > Resource Management > CPE Interaction Log.
All interaction logs are displayed in the CPE Interaction Log list, which contains the following
information.
• CPE Name—The CPE name, which is set to “OUI + Serial ID” by default. You can
customize this during the CPE adding procedure. You can click this link to open the
specific CPE Details page.
• OUI—The organizationally unique identifier number of the vendor.
• Serial ID—The CPE serial ID number.
• IP Address—The IP address of the CPE device.
• Operation Time—When the interaction log occurred.
• Description—The operation details.
Querying a CPE interaction log
To query a CPE interaction log:
1. Click Service > BIMS > Resource Management > CPE Interaction Log.
2. On the CPE Interaction Log page, complete the following query conditions in the Query CPE
Interaction Log pane:
• CPE Name
• Start time
• Description
• End time
BIMS supports fuzzy query function, which enables you specify an intact or partial query
condition.
3. Click Query to launch the query procedure.
4. Click Reset to reset the query conditions.
Managing a CPE Interaction Log 45