HP Intelligent Management Center v7.0 VAN Fabric Manager Administrator Guide

Table 9 Deployment procedure summary (continued)
ReferencesRemarksStep
The following are tasks you must perform to set up an EVI
network:
3. Create and deploy EVI
services.
• Adding an EVI service
• Deploying EVI services
• Specify a tunnel source IP address or interface.
• Specify a unique network ID.
• Specify extended VLANs.
• Configure up to two ENDSs.
VFM automatically performs the following tasks:
• Creates EVI tunnel interfaces.
• Create an EVI IS-IS process for each EVI tunnel. The
process ID is the same as the EVI tunnel interface
number.
• Specify a designated VLAN for each EVI network.
Managing EVI settings on
individual devices
When you add an edge device to an existing EVI network,
you can use device-specific EVI service management to
tune EVI settings on the device.
4. Deploy EVI services on
individual edge devices.
Maintenance task summary
To manage the EVI edge device pool:
• Viewing the device list
• Querying devices
• Viewing device details
• Removing devices
To maintain device-specific EVI settings, do the following:
• Viewing the EVI configuration of a device
• Querying EVI settings
• Removing an EVI service from a device
• Monitoring traffic size
To maintain EVI services, do the following:
• Viewing the EVI service list
• Querying EVI services
• Viewing basic information and topology of an EVI service
• Modifying an EVI service
• Deleting EVI services
• Undeploying EVI services
To monitor EVI link connectivity, do the following:
• Auditing EVI services
• Viewing history connect rate records of an EVI service
• Viewing the network topology for an EVI service
• Managing EVI links
EVI deployment and maintenance 111