HP Intelligent Management Center v7.0 VAN Fabric Manager Administrator Guide

Enabling immediate EVI service deployment
To deploy the EVI service immediately after it is added, select Deploy Now.
Alternatively, you can choose to bulk deploy EVI services later, as described in "Deploying EVI
services."
Completing the EVI service configuration
After you finish the previous EVI configuration tasks, click OK at the bottom of the Add EVI Service
page to complete the configuration.
Modifying an EVI service
Modifying the name and audit interval of an EVI service
To modify the name and audit interval:
1. Click the EVI Services tab.
2. In the service list, click the Operation icon for the EVI service, and then select Modify Basic
Info.
3. Modify the following parameters:
• EVI Service Name—Enter a new EVI service name. The name must be unique in VFM.
• Audit Interval (hours)—Modify the interval for VFM to test EVI link connectivity automatically
over the transport network.
4. Click OK.
Modifying configurations of an EVI service
To modify configurations:
1. Click the EVI Services tab.
2. In the service list, click the Operation icon for the EVI service, and then select Modify
Config.
3. Modify the parameters in the same way an EVI service is added. For more information, see
"Adding an EVI service."
Deleting EVI services
You can only delete an EVI service which is in Undeployed, Failed Deploy, or Failed Modify state.
Deleting an EVI service does not remove its devices from VFM's EVI module.
To delete EVI services:
1. Click the EVI Services tab.
2. Select EVI services from the service list, and then click Delete.
3. Click OK.
Deploying EVI services
You must deploy an EVI service into the network for the service to take effect. After completing the
deployment, VFM adds the EVI service automatically into the EVI service management page for
each related edge device. For more information, see "Managing EVI services on individual devices."
You can deploy an EVI service when you add it, as described in "Adding an EVI service."
Alternatively, do the following to bulk-deploy EVI services:
1. Click the EVI Services tab.
2. Select EVI services from the service list.
The EVI services must be in Undeployed or Failed Deploy state.
124 Managing EVI