HP Insight Control for Linux 6.2 User Guide

When a new set of credentials is entered with the Configure →Management
Processor→Credentials... task, Insight Control for Linux attempts to find a user with the same
user name. If one is found, the user password is changed to match the new credential. If no match
is found, then the new credentials are placed in slot 15, overwriting the credentials.
For this reason, do not store credentials, other than those for Insight Control for Linux, in slots
15 and 16.
24.2 Deploying WBEM provider components using Configure or Repair
Agents task
IMPORTANT: Installing the WBEM provider using the Configure→Configure or Repair
Agents task fails if you use a version earlier than RHEL 5.2 or SLES 10 SP2:
• SLES 10 SP2 and SLES 10 SP3 provide a version of libvirt and
sblim-indication_helper on the distribution media. For the Configure→Configure
or Repair Ag ents task to work properly, both must be installed on the SLES 10 SP2 or SLES
10 SP3 Linux Xen host. If these are not installed, the Configure or Repair Agents installation
fails with an error message. SLES 10 SP2 and SLES 10 SP3 also provide OpenWBEM CIMOM,
which must be removed or not installed on the SLES 10 SP2 or SLES 10 SP3 Linux Xen host.
The Configure or Repair Agents deploys Open Pegasus, libcmpiutils, Libvirt-CIM,
and sblim-cmpi-base to the SLES 10 SP2 and SLES 10 SP3 Linux Xen hosts.
To deploy the WBEM provider components, you must deploy the following components:
On RHEL 5.3 and RHEL 5.4:
• xen
• xen-libs
• kernel-xen
• kernel-xen-devel
• sblim-cmpi-base
• tog-pegasus
On RHEL 5.3 and RHEL 5.4, Configure→Configure or Repair Agents does not deploy WBEM
providers. In addition, you must perform these steps:
1. Install the following virtualization packages on the virtual machine host before registering
with VMM:
• libcmpiutil
• libvirt-cim
• sblim-cmpi-base
• tog-pegasus
2. Configure tog-pegasus.
3. To enable the root user to connect to tog-pegasus remotely, make sure the following line
is in /etc/Pegasus/acces.conf:
*:root:wbemNetwork
4. Restart tog-pegasus on the virtual machine host.
On SLES 10 SP2, SLES 10 SP3, and SLES 11:
• xen
• xen-devel
• xen-libs
• xen-tools
• kernel-xen
24.2 Deploying WBEM provider components using Configure or Repair Agents task 215