HP iLO 3 User Guide

4. Select File→Set Defaults.
iLO RBSU prompts you to confirm the request.
5. Press F10 to continue.
iLO RBSU displays the following message:
After setting to factory defaults, iLO 3 will be reset and this utility will exit.
6. Press Enter.
iLO resets and the server boot process finishes.
NOTE: If a server has an installed iLO Advanced license when you perform this procedure, the
iLO Advanced icon might be selected when the server boot process finishes. The icon will be set
correctly after POST completes, or after the server is shut down, powered off, and then powered
on again.
Server name still present after System Erase Utility is executed
The server name, as shown on the iLO Overview page, is the installed host operating system name.
If the Insight Management Agents are installed on the server, the agents will obtain the host name
and update it on the iLO web interface page.
To remove the server name after the redeployment of a server, do one of the following:
• Load the HP Insight Management Agents to update the server name.
• Use the iLO RBSU Reset to Factory Defaults feature to clear the server name.
CAUTION: This procedure clears all iLO configuration information, not just the Server Name
information.
• Change the server name on the Administration→Access Settings→Access Options page in the
iLO web interface.
Certificate error when navigating to iLO web interface
Issue: When you point your browser to the iLO web interface, a certificate error appears.
Suggested action: Use one of the following procedures to resolve the error.
Troubleshooting miscellaneous issues 231