HP iLO 3 User Guide

Figure 33 IPv4 Settings page (iLO Dedicated Network Port)
3. Configure the following settings:
• Enable DHCPv4—Enables iLO to obtain its IP address (and many other settings) from a
DHCP server.
◦ Use DHCPv4 Supplied Gateway—Specifies whether iLO uses the DHCP server-supplied
gateway. If DHCP is not used, enter a gateway address in the Gateway IPv4 Address
box.
◦ Use DHCPv4 Supplied Static Routes—Specifies whether iLO uses the DHCP
server-supplied static routes. If not, enter the static route destination, mask, and
gateway addresses in the Static Route #1, Static Route #2, and Static Route #3 boxes.
◦ Use DHCPv4 Supplied Domain Name—Specifies whether iLO uses the DHCP
server-supplied domain name. If DHCP is not used, enter a domain name in the
Domain Name box on the Network General Settings page. For more information,
see “Configuring general network settings” (page 72).
◦ Use DHCPv4 Supplied DNS Servers—Specifies whether iLO uses the DHCP
server-supplied DNS server list. If not, enter the DNS server addresses in the Primary
DNS Server, Secondary DNS Server, and Tertiary DNS Server boxes.
Configuring iLO network settings 75